What Is a Belly in a Sewer Pipe?

What Is a Belly in a Sewer Pipe? — Expert answers from Sunburst Environmental, Metro Atlanta’s drain jetting specialists.

A bellied pipe is a low spot in a sewer line where waste pools — and it causes recurring problems.

Sewer pipes are installed with a specific downward slope — typically 1/4 inch per foot — so gravity carries waste toward the city sewer main. A belly is a section where the supporting soil has settled unevenly, causing the pipe to dip lower than the intended slope. Instead of waste flowing past this section, it pools in the low spot.

Why bellies form

Soil settling — particularly in areas with clay-heavy soil like much of Metro Atlanta — is the most common cause. The ground shifts seasonally as clay soil expands when wet and contracts when dry. Over years, this movement can cause sections of pipe to lose their support and settle.

Root pressure and poor initial installation (insufficient compaction of the bedding material around the pipe) are other causes.

What a belly looks like on camera

The camera shows the pipe dipping into a low section where standing water is visible. Depending on the severity, waste may have accumulated in the pooling area. The camera captures both the low point and how far it extends. The depth of the belly and the length of the affected section determine how significant it is.

Why bellies cause recurring problems

Solids and paper products that would normally flow through settle in the pooling area instead. Grease solidifies in the pooled water rather than flowing downstream. Over time, the accumulation in the belly section grows into a blockage. Even after jetting clears the accumulation, the belly remains — and the pooling starts again.

What to do about a belly

Jetting can clear the accumulated material in a belly section — temporarily. It cannot fix the slope problem. The permanent fix is excavation at the belly location to repair the pipe bedding and restore proper slope. Whether that is worth doing depends on the severity of the belly, the frequency of blockages it is causing, and the condition of the surrounding pipe.

Call Sunburst Environmental at 678-799-4389 for same-day service across Metro Atlanta and North Georgia, or request a free estimate online.

Ready to Clear Your Pipes?

Serving Metro Atlanta and North Georgia. Camera inspection before every jet.